HX-F17 Series Semi-conductive Tape 5kv 130℃
| application | Rubber Tape |
| carrier | - |
| caliper | 151~200μm |
| construction | Single-side Tape |
| heat_resistance | 130℃ |
DESCRIPTION:
HX-F17 shielding tape is an ethylene propylene rubber based, self-amalgamating and conducting tape.
HX-F17 is ideal for use on power cable where accommodation of expansion and contraction due to load cycling is important. The excellent stretch of HX-F17 allows conformability to complex shapes HX-F17 is compatible with all extruded dielectric cable insulations.
Test Result:
| Item | Performance Index (Typical Value) |
|---|---|
| Color | Black |
| Thickness | 0.76mm |
| Tensile Strength | 1.3 MPa |
| Elongation at Break | 1000% |
| Volume Resistivity | 1×10¹³ Ω·cm |
| Water Absorption Rate | 0.20% |
| Self-amalgamation Performance | No loosening, no warping under 200% elongation at 23°C for 24 hours |
| Thermal Stress Resistance | No cracking at 130°C for 1 hour |
| High Temperature Aging @130°C | No cracking, no degumming, no peeling after 168 hours at 130°C |
| Long-term Light Aging | After 750h xenon lamp radiation exposure at 63°C: No significant change in tensile strength and elongation at break of the tape |
FOR SHIELDING HIGH VOLTAGE SPLICES AND TERMINATIONS
.Self-amalgamating
.Good conducting properties
.Easy to apply
.UV resistant
RECOMMENDED USES:
For electrostatic shielding on high voltage splices and terminations. Filling indents in compression connectors and rebuilding strand shielding on high voltage splices.Shielding bus and overhead connections.
INSTALLATION TECHNIQUES:
HX-F17 Tape is usually wrapped in half-apped layers. Highly elongate tape when over wrapping connectors semiconducting cable tape and semi conducting jackets.
Note: HX-F17 Tape is not oil resistant. It should no be used in splicing and terminating cables which contain oil or slippery compounds as part of dielectric Stretching HX-F17 Tape increases its conductance and will not harm it in any way.
